Keychain Remotes do not have a white battery activation strip to remove, and they are ready for use once you install your system. Additional Keychain Remotes do not have a USB installed, but function the same as Master Keychain Remotes. Keychain Remotes that have a USB installed on the top are considered Master Keychain Remotes, and there should only be 1 used per system. Also, if you hold down the “Away & Off,” buttons at the same time for 5 seconds it will arm your system in “Home,” mode. If there is an emergency, or someone breaks into your house while you’re home, hold down the panic button for 2 seconds to trigger the alarm. The Keychain Remote features three buttons, “Away, Off, and Panic.” If you are in a rush, or can’t get to your Keypad in time simply use your Keychain Remote to arm or disarm your system. It is small enough to fit in your pocket, and has a swiveling keyring that allows you to easily attach it to your car keys. The Keychain Remote provides an alternative way to arm and disarm your system. However, the remote will still work to arm and disarm your system, as well as trigger the panic button. You can also contact customer support to upgrade to our new SimpliSafe system that does not require use of the Keychain Remote USB. IMPORTANT UPDATE: With Adobe Flash discontinued, we are no longer able to update keychains as the remote’s software is no longer operational. If you're not certain which system you have, you can tell the difference here. Click here for the article for the Gen 3 SimpliSafe. If you purchased a new system in 2018 or later, you likely have the Gen 3 SimpliSafe. Listen for the Base Station to say the sensor name to confirmĪfter you have tested your devices, you can now either test your system connection by following the steps at the top of this page, or press the left arrow to exit Test Mode.Does your Keypad look like the one pictured to the left? Then you're in the right place! You've got the Original SimpliSafe system.Press the Test Button on the top of each sensor.Hold the Test Button on the front of the sensor for 4 secondsĮxtra Siren, Water, and Temperature/Freeze Sensors :.Listen for the Base Station to say "Panic Button" to confirm.Hold the Panic Button down for 2 seconds.Listen for the Base Station to say "Entry Sensor" to confirm.Open and close protected doors and windows.Glassbreak sensors will respond to any loud sound in Test Mode (whereas normally they only respond to breaking glass).Clap your hands loudly near your windows.Press Test Button on the top of the sensor.Re-enter the room and the Base Station will say “Motion Sensor".For an accurate test, leave the room for the sensor you are testing then wait 15 seconds.Press the Test Button on the top of the Motion Sensor.To continue with testing your devices, please continue with the below steps for each type of sensor. If you would just like to test your connection, you can stop here. You can also view the test event on your timeline via the SimpliSafe app. You will receive a call from our monitoring center to confirm the test.Press the left edge when you are ready to end Test Mode and return to the Menu.Press the bottom edge to enter Test Mode. Press the right edge of the screen to scroll to Test Mode. You can also send us a test signal to confirm that your system is connected, either independently of testing your devices or after testing them to make sure your system remains connected. Sending a Test Signal (while in Test Mode)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |